Microwave Oven Reaction Enhanced (MORE) preparation of substituted stilbenediamines

Robert J. Lancashire and Paul B. Reese

The Department of Chemistry, University of the West Indies, Mona, Kingston 7, JAMAICA.
Email addresses: rjlanc@uwimona.edu.jm and pbreese@uwimona.edu.jm

Abstract

Transition metal complexes formed from stilbenediamines have been of interest for some time. From the early work on the unusual solvent effects on the nickel complexes known as Lifschitz's salts to more recent studies where manganese complexes have been utilised in the chiral epoxidation of alkenes.
In an effort to shorten the preparation time of the compounds, the condensation of benzaldehyde with ammonium acetate has been re-examined under microwave conditions.

Introduction

It was observed by Trippett in 1957 (l), that when benzaldehyde was refluxed with ammonium acetate or ammonium propionate for three to four hours, a highly crystalline neutral compound, N-benzoyl-N-benzylidene meso-1,2-diamino-1,2-diphenylethane (C28H24N2O), was produced. Hydrolysis of this compound with 70% sulfuric acid over three hours was reported to yield meso-1,2-diamino-1,2-diphenylethane (stilbenediamine or stien).
More recently, there has been considerable interest in the use of the optical isomers of stien (either R,R or S,S) as precursors to catalysts used for enantiometric epoxidation of olefins (2) or as chiral Lewis acids to catalyse enantioselective Diels-Alder reactions.(3)
The difference between these forms can be seen in Figure 1.

Figure 1. (enlarged GIF, 16K)
New synthetic approaches to the optically active forms have been reported recently. These include the hydrolysis of a chiral imidazoline (4), and a new preparation of the racemate (3) which was resolved using existing methods (5).
As part of our studies (6) (7) on MORE (Microwave Oven Reaction Enhanced) chemistry (8) (9) we have repeated the reaction of Trippett in a microwave oven using benzaldehyde as well as p-chloro and m-nitrobenzaldehyde as substrates. We have been able to produce the meso compounds in two steps, with heating times reduced to approximately one sixtieth of those in the original paper. Products analogous to those formed in the benzaldehyde reaction are formed rapidly from p-chloro- and m-nitrobenzaldehyde.

Discussion

It is thought that formation of a 1,2-diphenylethylenediamine derivative under such mild conditions may be due to a benzoin-type condensation. This view is supported by the effect of substituents on the course of the reaction.(1).
Alternatively, the product could be formed by a condensation reaction between the aldehyde and ammonia (generated in situ) to give the imine which could undergo radical dimerisation. Further reaction of the resulting diradical with two molecules of benzaldehyde would lead to the adduct as shown in Figure 2.

Figure 2. A possible mechanism (16K .tgf file).

The products obtained from the the microwave reactions were identical to those obtained by classical reflux methods.
The yields in forming the adduct compared well with the reflux method, and ranged from 55% to as high as 81% which compares to 60% as reported previously (1).
However, the hydrolysis to form the diamine generally gave yields under 50%. Using the original conditions of 70% aqueous sulfuric acid, charring was often evident and so the acid strength was diluted to 50%. This necessitated extending the reaction time. The lower yields of the diamine could possibly be due to incomplete hydrolysis of the adduct.
The times used for the hydrolysis reactions were between three and four minutes, except for the p-chlorostilbenediamine when the reactants were irradiated for five minutes.

Acknowledgements

Aspects of this work formed the basis of several undergraduate projects, for which the authors gratefully acknowledge the assistance of: Noelle Finlay, Llewellyn Jarrett, Floyd Beckford, Roy Porter and Maureen Wilson.

Experimental

In general the methods of preparation of the compounds were similar.
All reactions were carried out in Teflon bombs in a commercial 600 Watt microwave oven (Sharp[TM] Carousel). The Teflon bombs were obtained from Savillex Corp. (60 cm3).
Melting points were determined on a Kofler-type micro hot stage block and are uncorrected.
Infrared spectra were recorded as potassium bromide (KBr) discs using either a Perkin Elmer 60 series or FTIR 1600 model spectrometer.
The mass spectra were recorded at 70 eV via solid insertion in a Finnigan GC/MS quadrupole spectrometer. Information from the 20 most prominent peaks was manually converted into JCAMP-DX format file for presentation.
Proton NMR spectra were recorded on either a Bruker AC200 or Varian T60 and were for deuterochloroform solutions. Tetramethylsilane served as the internal standard.

N-benzoyl-N'-benzylidene meso-1:2-diphenylethylenediamine.
Benzaldehyde (15.1cm3, 15g, 140 mmol) and ammonium acetate (30.12 g, 390 mmol) were added to a Teflon bomb which was sealed and placed in a microwave oven. The vessel was heated for three minutes, cooled and the mixture filtered. The product was washed with ethanol, air dried then recrystallized from toluene. M.P. 253-255 C (lit. 258-259 C). Yield 14.32g, 56%. The Mass Spectrum showed m/e at 404.
IR Spectrum (56 K GIF file).

The 200 MHz proton NMR (85K JCAMP-DX file) gave signals at 8.30 (s),7.79-7.24 (m), 6.71 (d) 5.55 (dd), 4.95 (d) and 1.55 (s).

meso-1:2-diphenylethylenediamine.
The adduct (5g, 12 mmol) along with 50% sulfuric acid (25 cm3) were added to a Teflon bomb and placed in a microwave oven. The vessel was heated for 3.5 minutes and then cooled. The mixture was extracted with ethyl acetate (3 times 30 cm3). The organic layer, which contained unreacted starting material and other impurities was discarded. The aqueous layer was made alkaline (pH~10) using KOH and further extracted with ethyl acetate. The organic extract was washed with water, dried with sodium sulfate and filtered. The filtrate was evaporated in vacuo. The product was recrystallized from methanol. M.P. 119-120 C (lit.120.5 121.5 C). Yield 2.62g, 24%. The Mass Spectrum showed m/e at 212.
IR Spectrum- (53K GIF file)
The 200 MHz proton NMR (85K JCAMP-DX file) gave signals at 7.41 (m), 5.41 (s) and 1.47 (s).

Preparation of adduct from p-chlorobenzaldehyde.
p-Chlorobenzaldehyde (5.04 g, 36 mmol) and ammonium acetate (10.06 g, 130 mmol) were added to a Teflon bomb which was sealed and placed in a microwave oven. The vessel was heated for 2.5 minutes, cooled and the mixture filtered. The product was washed with ethanol and air dried. The product was recrystallized from butan-l-ol. M.P. 251-253 C (lit. 249 C). Yield 1.5g, 31%.
The 200 MHz proton NMR (85K JCAMP-DX file) gave signals at 8.26 (s), 7.77-7.12 (m), 6.62 (d), 5.52 (dd), 4.96 (d), 1.69 (broad-s) and 1.28 (s).

meso-1:2-di-(p-chlorophenyl)ethylenediamine.
The adduct (0.9 g, 2 mmol) and 40% sulfuric acid (4.5 cm3) were added to a Teflon bomb which was sealed and placed in a microwave oven. The vessel was heated for 5 minutes, cooled and the mixture extracted with ethyl acetate (3 times 30 cm3) which was discarded. The aqueous portion was made alkaline (pH~9) using KOH and further extracted with ethyl acetate. The organic extract was washed with water, dried with sodium sulfate and filtered. The filtrate was evaporated using a rotary evaporator and the product recrystallized from methanol. M.P. 140-141 C (lit 137-138 C). Yield 0.24g, 51%.
The 60 MHz proton NMR (8K GIF file) gave signals at 7.25 (Ar-H), 3.9 (N-C-H) and 1.5 (N-H).

Preparation of adduct from m-nitrobenzaldehyde.
m-Nitrobenzaldehyde (5.14 g, 34 mmol) and ammonium acetate (10.14 g, 132 mmol) were added to a Teflon bomb which was sealed and heated in a microwave oven for 3 minutes. The vessel was then cooled and the mixture filtered. The crystals were washed with ethanol and the product recrystallized from butan-l-ol. M.P. 300 C (sublimes) Yield 4.01g, 81%.

meso-1:2-di-(m-nitrophenyl)ethylenediamine.
The adduct (4.01 g, 7 mmol) and 50% sulfuric acid (23 cm3) were added to a Teflon bomb which was sealed and heated in a microwave oven for 4 minutes. The vessel was then cooled and the organic portion extracted with ethyl acetate (3 times 30 cm3) which was then discarded. The aqueous portion was made alkaline (pH~10) using KOH and further extracted with ethyl acetate. The organic extract was washed with water, dried with sodium sulfate and filtered. The filtrate was evaporated under reduced pressure and the product was recrystallized from methanol. M.P. 184-187 C (lit. 189-190 C). Yield 0.63g, 30%.

References

[1]. S. Trippett, J. Chem. Soc., (1957), 4407-4408.
[2]. W. Zhang, J.L. Loebach, S.R. Wilson and E.N. Jacobsen, J. Am. Chem. Soc., 112, (1990), 2801-2803.
[3]. E. J. Corey, R. Imwinkelried, S. Pikul and Y. Bin Xiang, J. Am. Chem. Soc.,111, (1989), 5493-5495.
[4]. R. Oi and K.B. Sharpless, Tetrahedron Lett., 32, (1991), 999-1002.
[5]. O.F. Williams and J.C. Bailar, J. Amer. Chem. Soc., 81, (1959), 4464.
[6]. R.J. Lancashire and S.A. Clarke, Jamaican J. of Sci. and Tech., 4, (1993), 32-42.
[7]. R.J. Lancashire, (1990) unpublished results. See URL http://wwwchem.uwimona.edu.jm:1104/lab_manuals/MORE.html or here.
[8]. A.K. Bose, T. Tabei, V.S. Raju, Tetrahedron Lett.,31, (1990), 1661-1664.
[9]. D.R. Baghurst, D. Michael and D.M.P Mingos, Chem. Soc. Rev., 20, (1991), 1-47.
Return to top of article